Hi all, I’m currently in the process of fixing a decent water leak through the humble transom plate on a 99 crownline 225 with the mercury 7.4L and the bravo 1 stern drive. My current issue is while removing the gimble I accidentally broke the nipple on the gear line fitting that passes through...
Sweet so I can just pull that stripping back replace the screws and put it back without taking anything else off? Was just worried that stripping being one of those things that comes off but doesn’t go back on very well
When I said machine screw I meant like a wood screw not machine screw with a nut that’s my bad. But it pretty much looks like they took a standard screw you would use to put through a piece of wood and sent it through the fiber glass also I’m gonna post a picture of the bottom of the window...
So if I look under the dash of the boat you can see where there was a screw, it seems like they went and just machine screwed it through the fiber glass of the boat and didn’t use a nut and bolt. I’m thinking I might be able to drill a couple small holes and rivet the window frame back to the...
Hi everyone I have a 1984 searay seaville bow rider with the 3 part flat windshield. The left side got lose last season and it looks like the bottom frame piece pulled the screws out from the boat. I want to resecure the bottom frame piece again from under the glass so I’m wondering if anyone...
So now that it is a snap to install is it possible to change the hose without removing the bell housing and stern drive? Seemed that it was hard for people but possible to remove with everything on the boat and the install was the issue
Hello everyone!
Last year I purchased a 84 searay and have been slowly going through everything. Right now I am trying to figure out what to do about the water hose going from the out drive to the stern of the boat. All of the bellows are in great shape and look brand new but the water hose is...
I have a 1984 mercruiser 140 with an alpha 1 gen 1 serial number: 6805225
everything on the boat is great however sometimes after driving around for a couple hours if I shut it off and go to start it it’ll start run fine for a minute and then the idle will start to jump around and get pretty...
We have been fighting an over heating issue for a bit now first the impeller was bad and not pumping water second the thermostat was stuck closed third the passages on the exhaust side of things were gunked and we weren’t getting good flow fixed all of that and went out on the water and were...
First time posting in this forum but I’m hoping to get some good information...I just bought a 1984 sea ray seaville with the mercruiser 140 and aloha 1 gen 1 out drive the boat has been very well taken care of and has only been in the water for 5 years of its life, and is a 1 owner boat...
