I have a 1990 90hp force and I am sure that the reason there is no spark to any of the cylinders is because the Trigger is bad. I look at it and there seem to be a hard plastic that melted out the bottom. When I took it apart and removed the Trigger there was some small fragments of metal that...
On the flywheel there are 3 vertical lines(not shown in the manual). the center one is the longest with one that is shorter on ether side of the center one. Can any one tell me where Top Dead Center is and where would 28 deg. BTC be? I read some were that 28 was better than 30 BTC. Can some one...
I only had #1 firing so I changed out the CDI and took the old CDI and hooked it up to #3 and now I only have 1&2 working but still not #3. I checked all wires and ends (fixed some) Disconnected the black/yellow wires and it ran on 1&2 (would not turn off) which is what I expected. I can't test...
Can someone send me a photo of a stator in place on a 90hp so I can see where, in relation to the engine, the yellow wires sit? I am not sure but I may have placed the stator on wrong. God I hope I didn't.
I have 1990 90hp force(906X90C) and I am having problems. We were out having fun and it dropped all of a sudden in power. I have found out that the #2 cylinders are not firing and 1&2 are on one CDI and 3 is on the other. The manual talks about two cylinders not firing but only give a solution...
does the fly wheel have to come off? to test can a stator and trigger be test
I have a 1990/90hp Force(906X90C) and it was running fine when, all of sudden, it's WTO power dropped way down (3800rpm from 5400rpm).It is giving me some grief when it is started too. It has compressions of...
Can anyone tell me how to fix a striped port on the Tilt and trim pump base. I knew it was going to go but I had to try one more time. I have looked for the post but can't seem to find it.
I think that I am missing one of the two large springs, if there are two the book says it does. The book only mentions the 3 small check barings, so what about the large ball and is there supose to be a larg ball bering with the 2nd large spring? Where do these 6 brass washers go? The manual...
I need a Exploited view ot the TnT. Does any one know where I can find one. There is not one in the manual. When I took it apart things were not where they supouse to be. I think. Also there is only two springs and 3 small barings and one large baring. This pump has 4 side conectors and one out...
Hi, I am in need of what I think the manual calls it the Hydraulic pump base, it is the place where the hydraulic lines go into and the trim/tilt motor/reservoir are on top of. Where can I get one!! I have scoured the net and have no problem finding motors and a little trouble finding the...
Can anyone tell me where the battery, trim/tilt ground attach. <br />where do I attach the trim/tilt relays too. I can't find any photos that show these attachment points.
I cannot figure out where this purple wire goes for a Force 90 C/model. the only open spot is just above the ground wire's postion on the bar(port side) The side script says it is the 2nd STOP but there seem to be a flange of thin metel that over laps from the one 12v power screw. I have my...
Can some one help me find the serial # for this 1990 90hp Force? It'a Model 90-GX90C. I have found some numbers on the engine and they are:719518 & m839837. <br />Are either one of these it? The transom bracket has been chainged so it is not there for me to get that information from.
