Recent content by jusenough

  1. J

    Stumped no more

    I think I have finally figured out the problem with my 30 evinrude. Symptom - idles ok, runs fine to WOT initally but cuts in and out when warm. I had replace the entire ignition and fuel systems to no avail. Answer - 1989 & 90 30 thru 40 hp have a S.L.O.W. system ( speed limiting overheat...
  2. J

    Stumped

    30hp 1989 Evinrude. Symptom - Starts and idles.Initally runs to WOT and sounds fine.After warming I have a miss at idle and then it cycles raipdly on opening up the throttle.Tried spraying WD40 straight in the carb while it's cycling. No effect.tried squeezing the ball. No effect. After warm the...
  3. J

    Can't Figure it out. 30 Evinrude

    1989 30hp Evinrude. Engine sat for 5 years.I have replaced all fuel lines, did a carb overhaul, replaced both ignition coils and plugs and wires. Had fire on the bottom cylinder only. Replaced the power pack. Now I have fire on both but when I power up I have got cycling like a fuel feed...
  4. J

    30 Rude PS

    I allmost forgot. I have got 122lbs on both cylinders cold so I think it is probley somthing stupid like the machanic.
  5. J

    30 Rude Ignition - Timing or fuel?

    89 30hp Evinrude. This motor sat for 5 years. I have replaced - all fuel lines, primer bulb, fuel pump, primer selonoid, water pump. I cleaned the carb and did a kit. The float is set at level minus 1/16" with 3/4" drop ( the old float was set at level minus 1/4" with 3/4" drop). I only had...
Top