Recent content by justin101

  1. J

    spark problem

    johnson (tracker)<br />40hp,1992, model# TJ40ELENJ.<br /><br />Just rebuilt the carbs and tried to adjust them as per the book.(wont run with the 2-1/16" space at the spark control rod) Got it to idle some what good and shift into gear without dying with the spark control at 2-5/8". <br /><br...
  2. J

    fuel lines for a "92" 40hp johnson tracker.

    looking for a pic of the fuel lines going to the carbs. <br />I have the Clymers shop manual for the motor but dont see anything about the locations of the lines. I have one fitting on the top of the carb and what looks like a vacum fitting just below it. (same on both carbs)<br /><br />I also...
  3. J

    About soldering

    I saw a post that the person didnt know how to solder two wires. I just wanted to give a few details about soldering.<br />first its super easy!<br /><br />Take wires or part you need to solder and clean them off or strip back the cover on the wires.<br />So now you have stripped back or cleaned...
  4. J

    About soldering

    I saw a post that the person didnt know how to solder two wires. I just wanted to give a few details about soldering.<br />first its super easy!<br /><br />Take wires or part you need to solder and clean them off or strip back the cover on the wires.<br />So now you have stripped back or cleaned...
  5. J

    seal problem

    I'm getting water in the lower unit. I have replaced all the oil seals. Propshaft oil seal and O ring, Shift rod seal, drive shaft oil seal and the gaskets for the fill plugs. I think the big problem is no one can find my year for this motor so they just give me whats its close to..??..<br /><br...
  6. J

    info about a chrysler 35hp??

    I had heard you could turn a 35hp into a 50 or 55hp by doing something to the carb.<br />Is this true? <br />How do you do it?<br /><br />Thanks for any info......<br /><br /><br />Chrysler 35hp<br />Model #3551
  7. J

    Making headway on the 68 35hp chrysler model 3551

    Still looking for a good repair book on that model<br />to get the spark plug size and gap,points and so on. <br />The motor sat for about 6 years so far I have replaced the impeller, did a carb kit and replaced the seals in the lower unit. So far it runs great just needs the fine tunning. It...
  8. J

    Chrysler 35HP model 3551..1965 I think?

    I have a 1965 14ft larson with a Chrysler 35HP model 3551 motor on it. <br />The motor will run, just not very good. Also I have water in the lower unit. Bad seal?<br />So what I was wondering is it worth it to fix it or just get another motor? Are the chrysler engines any good? With it being...
See more
Top