Recent content by justinwerner

  1. J

    1978 J/E Power Pilot control box wire question

    I need to identify the purpose of this green/yellow stripe wire coming from my control box headed in the direction of my electric bus under the console, but is not connected to anything. Motor starts, runs fine, however there is no power to the bus, so all electrical components connected to the...
  2. J

    1978 Evinrude 115 Fuel pump inlet cover orientation

    My new to me engine has the fuel pump cover inlet hose pointing upwards. All pictures I see have the inlet line pointing downwards. The fuel lines look brand new and are wire tied in place so I cant simply rotate the cover 180 degrees to look like every diagram. I can clip the ties, extend...
  3. J

    Grounding wires attach what?

    My new to me 1978 Steury 1800 bowrider w/Evinrude 115 outboard came without a battery and therefore several loose pos/neg/ground wires. All the wire ends are hanging down in the stern area were the starter leads terminate and logically where a battery should be. I plan to tie them all to a...
  4. J

    Grounding wires

    My new to me 1978 Steury 1800 outboard runabout came without a battery. All the eletrical wires are hanging down in the stern area. They are easy to trace back to their components, but where to I attach the multiple grounding wires? Thanks in advance.
  5. J

    Ventilation tubes going to no-where

    My recently purchased 1978 Bowrider 1800 Outboard has a factory louvered vent each outside of the aft gunwhales. There are, for lack of a better description, four (2 each side) 3" plastic dryer vent tubes that just hang down and open to nothing around the top of the gas tank below the motor...
Top