Whats this plug for, that is on the back side on manifold towards the transom side? Whats this plug for and hole? Is it there for testing water temps or for inspection? and if so could one run a temp sensor there to monitor manifold temps??:confused:
See pic!
I'm having hard time finding replacment cap for my power trim pump reservoir. My existing one cracked inhalf, not sure how. But I need a new one, I cannot find any part #'s for this part. Anyone know if this part is able be bought?
I know there are diffrent type pumps etc.. but tank and cap...
I have a quart of the interlux bilgekoat white, or some left over. I want to make it grey, as I understand the paint is a enamal, how can I tint it to gray? Can I just add some enamal black to it? Will this work or is a special type enamal paint? I'm using it to fill in some cracks that are...
I pulled my drive this weekend to do alignment and replace my impellor, Alpha one gen II drive etc... When I split the lower from upper, I noticed that the face seal on top of my impellor housing was not there. Now the new kit I have has it in the kit. So did mercruiser make a change at some...
Well I was going over some parts and there names; noticed that in this parts list and exploded view it all wrong? Good God! No wonder many people get the names wrong! Look at Impellor part list #'s
I was just wondering if the bellows glue is used at this inner bell housing seal when putting the drive back on? Do you use the same glue that the bellows uses?
The manuel states to use glue but not type! See photo!
Doe's anybody know what size these nuts are? The jam nut looks the same size as the lower mount nut,and the adjustment also looks the same size, But do not know the size! Also how is the heck to you loosen these on a 175 bayliner BR with 3.0 Merc. engine?? It's real tight in there with a small...
