Recent content by K.B

  1. K

    Fuel Pump Kit

    Good eve' folks! I have run into a dilemma. Evinrude 40 hp '71 model (40153g). Fuel pump has gone out, very sporatic pumping w/ hose disconnected at carb. Book says no kit, not servicable. Is this still true? Can't give $98 for new one. That's unacceptable. Only needs a diaphragm. Old...
  2. K

    Carb filter

    Good eve! I have a 10 HP Johnson (QD-18) that I have found the brass filter for finally, but do not have the threaded turn "wheel/screw/keeper" that holds it inside the glass bowl. Anyone know the part number for this. I have a repair manual, no parts manual. GREAT running motor, but haven't...
  3. K

    gear sets

    Good evening! I am curious as to whether or not a set of '62 John. Selectramatic gears are the same as the gears on a manual shift. Are they just put on the coils with the three set screws but still have the dog clutch form on the inside or just a "whole different animal"? Any of this make...
  4. K

    rubber bumpers

    Good evening! This is a rather strange request to all who have the '56- '58,9 7.5, 10, 15 etc. My 10 hp is missing the rubber bumpers on the front of the engines side plates that the cowling's cups slip into when you put it on. These keep the hood tight so it dosn't rattle. I know you can't...
  5. K

    high idle speed

    Good evening everyone! I have a 71 model 40 hp e'rude (40153g) that I am enjoying IMMENSELY! (as it was free!!). Still have a strange, to me, situation. It idles too high, once again, to me. I have no tach, no speedo, bare bones. FD model Alumacraft that it is on. Link & Sync is done...
  6. K

    Prop Nut

    Hi all!! Out of curiosity I am wondering if the prop nut is still available for a '71 model e'rude 40 hp (40153g). It really isn't a nut as it is the one that does not thread, it only slips on with a peg that slides down a keyway on the prop shaft and the cotter key keeps it on. REALLY hate the...
See more
Top