Thanks, I was afraid it must be the fuel pump, considering I've been eliminating other things one at a time. I did replace the two fuel filters that I was aware of (the first one with the view bowl that filters before the pump and then the high pressure one that I wasn't aware of at first since...
Hello again. I relied on iboats to walk me through a total tear down and rebuild of an old 1956 outboard a few years ago but now I'm on to a newer motor. I am having some issues so I'm hoping the good people on these forums can help me figure this out.
I purchased a pontoon with a 60 hp Mercury...
Hello everyone! I'm SO SORRY I left you all hanging, I truly am. You've all been so wonderful to me and I apologize for that. My son got married in Kansas and I was out there prepping for that for a couple weeks and now my daughter will be getting married in a couple months and I'm on to that...
Hi everyone. I started on here in 2012 restoring a vintage boat and engine. I finished it but after a couple years of being too busy to use it, I have decided to gift it to a wonderful family with three kids who practically live on lake water and sunshine. I was getting it all ready to give to...
I am stumped as to how to remove my carburetor so I can use the carb kit I ordered. I removed the fuel line, but I'm not sure what to remove regarding the throttle linkage (see picture "F"), perhaps the cotter key? And I am absolutely confounded by how to access the two nuts holding the carb to...
Can anyone tell me the part number for a 1956 Johnson Javelin carb kit WITH float? I'm off the lake until I can order it and repair the carburetor. Thanks
I apologize for starting a new thread but I had no replies on my other thread (which had started with a different topic). I'm at the end of my rope and ready to sell this motor if I'm too stupid to figure something this basic out. Here's the scoop. I had to remove the upper and lower carb...
Hi everyone. If you've followed my saga before, I restored a 1956 Johnson Javelin and it ran great. Last summer I did a rewire on it to get the start button and kill switch to the front of the boat instead of the rear. LONG story and many posts, but finally successful. When I took her out for...
I spent the summer working on this motor, if anyone has followed my saga of the starter solenoid and rewiring process, I finally got it to start and run. But the motor wouldn't run full power when I lake tested it and it sounded noisier and just "off" compared to how it used to run. WillyClay...
Does anyone know the part number for a 56 Javelin starter? Where would you recommend getting one from and if you know, what's the average price? Thank you.
Hello again my forum friends. It's hard to believe but it's been 5 years since I sought out help from you all to restore my old boat and motor. I could not have done it without this forum and I'm forever grateful. I had zero motor/boat knowledge before this experience so I credit you. Now I...
I purchased this boat, trailer and motor last summer simply because I needed the motor for a boat I already own. I want to sell the boat and trailer locally and I'm just throwing out the price of $300 (it floats fine, I used it last summer and no holes, no problems) but since I haven't had any...
I was wanting to sell a couple vintage gas tanks online and I don't know how to go about the shipping process. From what I've seen on Ebay, sellers list a shipping price so I assume they are using either USPS, UPS or FedEx but I don't know what the restrictions might be on an item such as this...
Re: 18' 1969 Offshore V restoration
"however I will soon fool you all with glossy photos from 50 ft away on a sunny day." Hahaha! Love it! Thanks for the reply and the great information, I really appreciate it! My boat is only a fourteen footer, not sure the length of yours but how much white...
