FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
First off thanks to everyone who's been helping me with everything.
I have a 2004 Mercury 60hp 4 Stroke.
Water spits a little out the peep hole then stops...
A) I hooked a hose to the pee hole to flush it and water comes out the bottom like it should.
B) I replaced the rubber impeller as...
Okay, should be in the right category....
I have a 2004 Mercury 60hp 4 Stroke.
** Do these have a oil pressure sending unit, if so where is it located? If not can you install a oil pressure sending unit and gage?
** Does this have a thermostat? If yes, where is it located?
** Does this have a...
2004 Mercury 4 Stroke 60hp.
Do these have a Temp. sending unit? If so, where is it located? What wires connect to it? If it doesn't, where do you put one in at? I want to put in a Temp gage in....
8 prongs on the big wire. That goes to the engine. The wires coming out all have female ends.
The other wires from the control box have 3 Male ends and one Female end plug the plug.
I have a 2004 Mercury 4 Stroke 60hp. I have 3 questions, I sure could use some help with.
I'm replacing the control box. A new one just arrived. Coming out of the bottom of the box there are some wires.
1) A large wrapped one with what looks to have a plug in for something. What is it for, what...
