Current visitors

Home
Members

kenny nunez's latest activity

K

kenny nunez replied to the thread 1993 Four Winns Horizon Neutral Safety Switch in Shift Lever bad/need replacement.

Post a picture of the control.

Yesterday at 7:46 PM
K

kenny nunez replied to the thread Trim Hydraulics.

The rods are binding in the packing glands where they extend out of the ram tubes. Sierra marine rebuild kit. # 18-2291. Sierra also...

Tuesday at 4:20 PM
K

kenny nunez replied to the thread last piece then peace! red cable red part.

Google Morse OMC cable adapter. I just saw it on e bay

Tuesday at 4:08 PM
K

kenny nunez replied to the thread AQ125, what is this wire?.

It looks like the current alternator is a Delco 1 wire self energizing. The original Paris Rhône alternator used the wire in question...

Friday at 12:52 PM
K

kenny nunez replied to the thread Testing Gas Flow on 82' Wellcraft Sterndrive.

Be sure to pull the suction tube from the tank and push out the fine mesh screen that is inside it, quite often that is where the...

Apr 11, 2025
K

kenny nunez replied to the thread Bravo 3 engine installation / alignment.

If there is room under the engine get a small bottle jack under the harmonic balancer to raise or lower the engine.

Apr 2, 2025
K

kenny nunez replied to the thread HELP!!! Monterey 256 Sport Cruiser 1996.

Just as ESG posted you need to look at the #8 cylinder. Remove the valve cover and watch that both valves move the same amount when...

Mar 30, 2025
K

kenny nunez replied to the thread 2002 5,7 Mercruiser exhaust manifold keeps cracking - 5 times this summer.

One thing that that was mentioned how the “problem” engine‘s power was less than the other needing more throttle. Since these engines...

Mar 10, 2025
K

kenny nunez replied to the thread Lubricating starter motor shaft 5.0 MPI.

Sometimes there is just enough water that the flywheel will sling it around when getting on plane. I can remember where the solenoid...

Mar 10, 2025
K

kenny nunez replied to the thread Replacing head gasket in 3.0 mercruiser.

You should specify for marine use.

Mar 6, 2025
K

kenny nunez replied to the thread Quadrajet Accelerator Pump Rod in Rebuild Kit.

Many quadrajet kits I have used in the past had the wrong rod so I would just put the new cup on the original rod.

Mar 6, 2025
K

kenny nunez replied to the thread Do I replace the core plugs when engine is out?.

If the engine is fresh water cooled I would leave them in place. However I have been surprised in the past to see how much crud had...

Feb 18, 2025

Show older items

Home
Members

Top