Recent content by Kennym2022

  1. K

    35 hp 1976 Johnson rough idle to no start

    Yes that’s what I meant, thanks for the help either way
  2. K

    35 hp 1976 Johnson rough idle to no start

    Welp, I’m a little retarted I guess. I took the air box off the carb to check something, and figured I’d try starting with the air box off, and it started right up and idles nice. I think the gasket between the carb and air box is torn and was covering the vacuum port on the carb
  3. K

    35 hp 1976 Johnson rough idle to no start

    The motor used to immediately start before I touched the points
  4. K

    35 hp 1976 Johnson rough idle to no start

    Model 35rl76s
  5. K

    35 hp 1976 Johnson rough idle to no start

    Did not switch plug wires, though I did move the under flywheel coil by accident
  6. K

    35 hp 1976 Johnson rough idle to no start

    Hey everyone, I’ve got a 1976 35 hp Johnson, and when I got it out this year, I found it had developed a rough idle, but was fine at top end. I cleaned the carb, and reset the points, but after resetting the points to .020, the engine would no longer start, if you crank it, it will sputter and...
  7. K

    looking for advice on a 1996 merc 15 hp.

    Oh yeah I was super excited
  8. K

    raising transom on a boat for a long shaft.

    Yeah I’m trying to find a pin, and it’s just normal 3/4, non ground contact, and I’m encasing the whole thing in fiberglass resin
  9. K

    raising transom on a boat for a long shaft.

    If by solid you mean sturdy, then no, it flexed a lot, now, yes
  10. K

    looking for advice on a 1996 merc 15 hp.

  11. K

    looking for advice on a 1996 merc 15 hp.

    Yeah, I ended up finding a tiller 35 ho Johnson for free, guy repowered his boat and said whoever messages first gets it. I shot him a message and I got it. I asked him how fast I was and he said about 2 minutes. Motor runs beautiful, electric start
  12. K

    raising transom on a boat for a long shaft.

    No clue, the previous 2x6 def wasn’t original
  13. K

    raising transom on a boat for a long shaft.

    That’s how it turned out
  14. K

    raising transom on a boat for a long shaft.

    Before it just had a 2x6. I traced the back and put 2 1/4” plywood bottom to top
  15. K

    raising transom on a boat for a long shaft.

    Sorry meant 3/4 layered. My final thickness was 2 1/4 in thick
See more
Top