Guess what?? They changed the rules AGAIN. In 2007 the law was under age 6: must wear a pfd at all times. Now in 2008 it is under age 13: must wear a pfd at all times. The marine patrol was nice enough to explain this yet to be published rule, and only charged me $50 for the priviledge of...
Hi.
I have done post searchs for past info, and the following. keyswitch/lanyard circuit tests OK. Stator resistance tests ok for charging coil and ignition coil. motor ran fine for the first run of the season, for about 20 minutes, then a small backfire at 3000rpm, and then dead in the...
Hi. Just bought a Faria system check tach for my 2002 90hp johnson. No instructions came with it. there is an adjustment on the back...pulse/rev, which can be set to 5 or 6. 5 is 10 pole, 6 is 12 pole?? Which would I use for a 2002 v4 90hp?? thanks alot.
Hi. Looking to repower a 16ft skiboat in spring 2008. What are the best years for used J/E 20 inch leg outboards in the 90-115hp range. I can probably only afford motors in the 1990-1997 age group. Please explain why its your favorite. thanks in advance!! ps...any years or types to avoid??
title says it all. plugs 1-3 all look brownish after use. cyl 4 plug,the lowest cylinder, always looks white.the motor runs so-so.starts great but performance should be a lot better. any ideas?
Hi. 13 inch diameter aluminum mercury prop mounted on an 85hp merc outboard. It has HHM2200 4 stamped on the hub.I can not seem to find its pitch info anywhere. Any ideas of where reference charts are located?? thanks in advance.
You guys make it look easy...so here goes. New to me bayliner with a repowered older merc outboard. I have checked other websites,serial # charts, etc, but can not confidently pin down the year. On the engine block is 3872124. on the transom clamp is 6345015. 4 cylinder,850(85hp) according to...
Hi. I have a 76 merc 850 OB. It has the old style 4hose,inboard mounted trim/tilt pump. Does anyone know where to get reasonably priced(read cheap) hydraulic hoses? I need two of the larger hoses. thanks in advance...Sean.
