Some time ago someone here told me to cut the large orange wire going to the alternator on my 4 cylinder chevy motor and hook it directly to the positive post on the battery. Does this makes sense? The orange wire on the ignition switch is then disconnected right?
Larry E
At the bow end of my bilge pan on my 16 foot Seaswirl I/O there is a hole 2" long and 1" high. I have had people tell me it supposed to be there to allow water from the front of the boat (should it be there) drain back into the bilge. Should I leave the hole or seal it?
Larry E
This summer I experienced a leak under the rear right hand side under the decking of my 74 Seaswirl. The boat was in a slip for two months and the carpeting would be soaked in this area, but not the rest of the decking or carpet got wet. Some how the water would make its way into the bilge so I...
Can someone tell me if the original decking on a 1974 Seaswirl V hull 16 foot boat is glued down or are there screws holding it down? I cannot tell because of the carpet glue on the decking.
Thanks
Larry E
I am trying to get the gear and shaft that holds the Trucourse cable to the intermediate housing out. I removed the one screw that supposedly holds the shaft in the cable drum but the shaft and gear will not budge. Any suggestions?
Thanks
Larry E
I could use some good info on removing the flooring and replacing stringers on a 1974 SeaSwirl 16 foot. Pictures would be a large help...
Thanks
LarryE
How do I get the volume up on this unit so I can hear the pinging when the fish are picked up on the unit? I had an older Hummingbird that pinged everytime a fish was marked.
Larry E
I have a 4 cylinder 2.5 motor. I am wondering whether the water supply hose from the intermediate case goes to the strarboard side of the thermostat housing or the port side.
Thanks
Larry E
Is there anyone here that runs an OMC Stringer that never gets any water in the bilge? I have been told that it is common to have a certain amount of water in the bilge after being in the water for a day.
Larry E
I have a canvas top on my boat that has hardened and stiffened over the years. It looks to have been an expensive type top made in a custom top shop that is no longer in existance. There are no tears in it but I would like to put something on it to soften the material. What would any of you...
Had my boat out to the lake the other day. Ran it for a good hour at different speeds and all worked as advertized. I am curious though as to whether the alternator is charging or not. The volt gauge reads 12.5 all the time and the battery never runs down. I thought it should read around 13.5-14...
OK took the boat to the lake yesterday for its maiden voyage after 6 months of restoration. Everything works better then advertized except for the engine temp. Ran it for at least an hour at all speeds. Engine never got hot. temp gauge never hardly moved. Large hose to water pump was warm to...