Does anyone have an idea where to access online information (parts catalogue) for TRS drives?I am trying to identify the oil seal between the bellhousing and drive unit,that allows a watertight connection for the gear oil fron internal reservoir to reach the drive.<br />This one got damaged when...
I have just purchased a 30 offshore with fresh 454 Mercruiser/TRS330's.Except for the manifolds and risers there in no exhaust installed.<br />Can anyone fill me in on what is required to complete the exhaust installation in order to provide good flow and prevent any back flow into the...
I am in the process of converting the old Stringer mount OMC to a Meercruiser/Alpha1 drive.Can anyone direct or inform me on where to locate the specs with regards to engine mount heights,transom cutout and alignment?<br />I could build a jig based on some rough dimensions taken from a scrap...
I need to know on average, how thick is the transom (excluding glass skin)on a 1979 25-26ft Searay?<br />When trying to rebuild this transom what would the best type/grade of plywood be?<br />Is it better to use thin plywood and laminate it biaxially with epoxy resin to make up the total...
Can anyone help with a wiring schematic or diagram for Bennett trim tabs?To the best of my ability I have checked the current flow from power source through the switch but do not quite understand how the valving at the control unit works.The port side tab functions normally,but i can hear a...
I have a 22ft Reinell of 1974 vintage, with a 165hp OMC outdrive.This is the electric shift model.Is there an easy way to determine the series (400/800 etc) or is this a drive of a different era? Second to that,is the transom cutout (bellows type),a standard size or are the later models smaller...
