I bought this motor cheap knowing I had to replace a water pump impeller, as former owner said it wasn't pumping water. Bought an impeller(not cheap-paid more for it than I did for the motor), tore motor down, water pump impeller looked good but changed it anyway as long as it was apart. Started...
Generally speaking, will a prop from a 2002 50 hp fit a 87 Classic 50-45 hp? I know there are issues with pitch etc. Is there a web site that has compatabilities, say if you know engine size and/or part #, etc? Thanks
OK all you Merc fans, will either of these props fit the above motor? Part # 48-77349 A40 or # 48-73136-13. Are these part numbers available somewhere on-line for referencing purposes? These are supposedly both 13P props and that is what I'm looking for. Thanks!
My recently acquired fishing boat has a post (about 3" dia, I think) that has a screw type base. You put it in the floor and then turn (screw) it in tight. The screw is about 3/4 of an inch(dia) or so and about an inch high. Anyone know where I can find this type of post. I've looked at most...
I've read many posts about what to hook to what battery but some are either fuzzy or I'm extremely dense. Should ALL electric and electronics be hooked to the deep cycle and have ONLY the motor connected to the starting battery? OR? Thanks in advance for what I know will be excellent advise.
Just acquired this engine. Started fine but no water pumping-shut down right away. Bad impeller or ? Best source for impeller if needed? Thanks. 1966-67 Model 9601 Ser 3125
