Hi Rodbolt<br /><br />The multifunctional gauges got shot as a result of the heat from the sunlight in this environment and I am thinking of replacing them with analogs. i KNOW THAT THERE WILL BE MORE GAUGES TO INSTALL BUT i WILL SAVE BIG BUCKS. wHAT IS YOUR TAKE ON THE SUBJECT ? tHE TECH HERE...
Hey mon.<br /><br />I have put up the 225 hp for sale, guess it will take a while ..will let you know when I am ready for the four stroke motor. The news from the guys that have them here is that they are quiet and very fuel efficient. A few have encountered fuel pump problems.Has that been...
Happy New Year Mon !!<br /><br /> Have they now perfected the four stroke yammie?<br /><br />I am updating my 1994 225 SWS but they dont seem to make a 25" shaft anymore in the two stroke model . I am trying to decide between the 200/250 hp, i.e the ox66/EFI model.. got any idea which one would...
Hey guys. Please assist !<br /><br />I notice That the motor is overheating at low speed or at idle and the alarm comes on. It would dissappear once the speed is increased at higher revs. The thermostats are okay. Does this mean that the impeller is going ?
Anyone knows where I can get one of these shirts like what the fishing pros (on the outdoor channel) wear? Usually has the decals i.e " Triton Boats, Citgo, Mercury etc..I have looked all over the net, but none like this.Thanks.
Can anyone help?<br /><br />I have tried acetone, a sharpe putty knife. I am afraid of damaging the gel coat. This old tape is literally baked on . Is there an easier way ?<br /><br />Thanks
Rodbolt,<br />I find that AT TIMES it is a little difficult to put motor in gear. .. more so in reverse.This is so whether the engine is on or not. I have put some grease on the linkages under the cowling but the problem is still there. I must admit the linkage at the basin (bottom tray)is hard...
This system came on my 1991 Proline and has " Morse D 306900-Japan " marked on the black cylinder behind the steering wheel. I suspect that this model is outdated. There is a leak under the steering and I am wondering if a seal kit is available for it.Other than that It works very well...
Hey Guys, any suggestions here ?<br /><br />I disconnected the VRO system and mixed fuel at 50:1 and motor ran well for a year. I do a lot of trolling and after 4 to 5 hours at 6-10 mph the motor shuts down. After that its a hastle to come ashore, but after restarting and priming the bulb...
I have a 24' proline w/a with a 225 yamaha (2 stroke)on single bracket. I would like to upgrade to 2-115s. That means I will have to replace the bracket as well. How will the additional weight affect the whole configuration of the boat ? The weight of one of these 115s are nearly the same as...
