Have 2 Sea Doo SPX 1995 and both are leaking through one of the welded in discs in the exhaust pipe water jacket housing. (Purple pipe.) Has anyone had this peoblem? Sugestions for repair?????????
Bought a 21' Lowe aluminum deck boat, Mod 2200 with an OMC 3.0. Prop is aluminum 3 blade 15X17. Runs about 36 with 3 onboard at 4600 rpm. Is this about what I should expect?
I have a 92 OMC 3.0 HO. When I remove the manifold drain plug and even remove the drain fitting, even after punching wire in the opening, I can't find any kind of hole. It just feels like a smooth flat surface inside the hole. I always put antifreeze in the manifold and block, so no problems. I...
Have a 1992 OMC 3.0 HO Cobra. Exhaust flapper fried and plugged exhaust in drive. Unit has gasket only where riser connects to manifold. Some exploded parts diagrams show upper and lower gasket with a restricter. What is the right answer. (flapper is almost impossible to find but I found 6)
I have a 1992 Lowe 2200 deck boat (aluminum). It is leaking around rivets mostly along the keel. I am sure other rivets here and there are leaking. I have heard of some owners having the bottom of their aluminum boats coated with bed liner in the Tulsa OK. area. The boat has a flat floor that is...
1992 OMC Cobra 3 liter HO (GM). Looking for a flapper valve. Does anyone know where to find one? Dealer said out of production and out of stock. New production will start at a later date.
I don't know who engineered? the OMC flapper but I don't think plastics are the right material to place in...
Does anyone know how to test an OMC trim gauge off the boat with an ohm meter. Sender seems to be OK and reads 200 ohms up and 0 ohms down which manual calls for. Boat is in another state for now but I have gauge here and have opened it and repaired a broken needle. Would like to test it.
Gauge...
I have a 1992 Cobra I/O and the trim guage needle seems to be loose. The guage does seem to try to work. Where is a reasonable place to have it repaired? I have heared the sending unit for these is impossible to find. Is that so?
Just bought a 92 Lowe deck boat with a 3 liter H. O. (OMC) GM 4 banger. Has fresh engine, (old one wasn't winterized and was ruined). I see on the forums that Merc says use 25W40 in it's engins. What would be the proper oil for this OMC rig? Where would you get 25W40? I have never seen it on...
I have a 78 Johnson 70 hp and get noise on the radio when engine is running. Guess I need some sort of suppressor. Can I get it at Radio Shack? What do I ask for and where do I install it ( which wires)?
Lots of people seem to have trouble with carbs. Ben sitting a long time, old gas, gommed up and so on. No one talks about usung Sta-Bil in your gas. Available at Wal Mart and parts houses. I live in CO and have a lake house in OK. Have 2 outboard boats and 2 jet skis. I keep Sta Bil in all 4...
Johnson 10 Mod JD-22 S Ser 2213723 Couldn't stand the pukey puddy grey? color. Painted it off white cover with dark green hammered look metalic below. Red Letters looks great, runs great. Colors similar to a 60 John I had back in the mid to late 60's.
