Have a 1850CC (1992-94) and am trying to find some replacement doors for the console (with or without trim) and also a windshield (frame seems ok, but plexi is all broken). Have pictures if that would help.
Any help would be greatly appreciated...thanks.
Trying to help out friend in Bahamas who has older Evinrude 55HP (circa 1978?) which needs lower end unit. I cannot seem to find code for year for this engine which is....
Model SR55RSLH
S/N - G 7753070
Also - any ideas if I could find him a lower end unit for it?
Thanks.
Have a 2001 Evinrude 150 HP (FICHT) with 100 hours that sat unused for 5 years and recently had mechanic get it up and running fairly quickly without much trouble - and it runs fine at low RPM's.
However, I've been warned that once I put higher RPM's to it, there could be problems... as these...
Have a Hydrasport 1850 CC sitting in the shop in the Bahamas and would like to buy a protective canvas cover for the center console section, but do not have the required dimensions.
Was hoping someone provide (and perhaps a supplier) so I could get a console cover for it here in the States?
Thanks.
As a follow up to earlier email, had another question regarding a boat that has sat for a while, and many of the instrument face plates have been broken due to kids throwing rocks in the boat.
Is there a way/process (perhaps with an ohmeter) to check any of the follwing gauges without the boat...
Was hoping to get some advice on a boat located in the Bahamas.
Inherited a 19 ft HydraSports with a 150 HP Evinrude (2001) engine (400 lbs) that has sat for a while during which time someone stole the Hy-Trac hydraulic steering system out of it (cost of $1700 over there).
Am looking to get it...
Happened to inherit a HydraSports 1850 sitting in the Bahamas on davits that has not run for 6 years and suffered a lot of elements damage and some vandalism.
Am going to try and get back running and am looking for information and resources as Genmar cannot provide much.
Was wondering if I could...
