I thought my problem was in the tilt/trim switch so I bought a new one, wired it in and the problem is the same. I have it narrowed down to the pump relays (I think).
The pump I have is a SAE J1171 Marine. It will bring the lower unit up just fine but it does not want to push it back down...
Does anyone have instructions for changing out the tilt/trim button?? Also I could use the electrical specs on the switch if available. I have attached a picture of the unit. It reads Mercury 3000 Classic on plate. I am not wanting to change out the whole unit. I would like to change out...
As the title says, the outdrive is not trimming back up.
When I pushed in the "up" button on the shifter handle I would get nothing. If I pushed in the "trailer button" I would hear a click. When I pushed in the "down" button the unit would go down.
I figured it was the trim sensor, so I...
2001 merccruiser 8 cly 5 liter carb. motor
Does anyone know if changing the tach would effect starting. All i did was change the tach and now the boat will not start. Seems like a no fire situation.
voltage readings to each tach post would be helpful.
Any ideas would be great Thanks
My live well often doesn't fill. If I turn the live well pump on before launching the boat, then it will fill. If I get the boat on plane and trimmed out, when I come off plane, then the live well does not want to fill again. Is there a way to prime this after I put it in the water or come...
I have a 20 ft Hurricane deck boat with a 240 hp Mercruiser 5.0 L engine. It has an alpha outdrive.
Currently the boat has a Michigan Wheel prop on it. Part # 992203, 14.5 x 18 RH 4 Blade prop. The prop is a bit dinged up but not too bad. I would like to replace it with a prop that will...
I have a deck boat with a Mercruiser 240 I/O and an alpha outdrive. The drive serial # is OL788504, the transom serial # is OL884895. This outdrive will trim up in any position but to trim the unit down I have to turn the steering wheel until it is in the "sweet spot". I think I may have...
