Thanks a lot for all your help!
-So I'm replacing all 4 lines,
-installing all new ones, and fastening tightly
-Keep the drive down, and check fluid level on trim pump via slotted head screw
-Fill up to proper height if theres a dip stick
-Go both up and down cycles a couple times (WITH THE...
i got it thanks. gen 1 alphas are 15-9/16th. $105 from SEI.
Now I have the older SAE J1171 Marine and I'm not sure how to add or check the fluid with that model. The newer ones have a resevior which would be nice. Also is there a good way to bleed these lines? Can you put all 4 new lines on...
Hey guys I was trimming up and blew out a trim line , I believe the UP. I’m trying to find the right replacement and there’s so many out there. Some look like 15+” and other is 16+” are my 2 choices. West marine sells one but it appears to be black and not the metal braided silver looking one...
Guys, do the two anode bolts on the gimbal housing run through the transom? I’m in the midst of replacing anodes. On one side it was seamless, the other side it looks as if the stud is moving too ever so slightly. Is this a place where water can enter transom? Thanks!
Okay thanks! Should that little black peice that’s towards the throttle plate move at all? Because I can give it a good back and forth movement by an eighth inch.
Hey thanks for the reply! The cam is not original. It’s a slightly bigger one nothing crazy. Can barely even hear a loping sound at idle. I will go ahead and check the cable as AD said. I can move the little black peice around back and forth it has about an 1/8th of movement (enough to change...
Hey guys, I have a Rochester quadrajet on my merc 5.7 and the idle is never the same. I got the boat and the choke was bypassed and is zip tied open. So of course needs some advanced throttle to start. When I come back to neutral it’s sometimes 1100 rpm’s, once it’s warm off plane back to idle...
