im using a duplicolor BSP300 clear coat. http://www.duplicolor.com/products/psFinishSystem/
and im pretty sure i need a hardener for it to reduce the likelihood of it chipping and fading.
i found this one that says its a enamel hardener, can i use this? do you have any suggestions as to what i...
ok im trying to lube my merc gen 1 strendrive and when i hook up the grease gun i am not able to put grease on. i give it 3 pump and the pressure pushes the grease gun nozzle of the zerk. i end up with a blob of grease over the zerk. what is the problem? full of grease possibly, ps i didnt...
im looking to change my ignition from a normal key to a push to start button i found on amazon. Is this a possibility since it should be just like a car. Would there be any drawbacks or reasons i shouldnt do it.
Heres a link of what im looking at...
So I put new plugs in and now when I'm reving engine quickly and bringing the throttle back it seems like the engine struggles to sustain the idle for a second then returns to normal. I took one plug out and it looks wet, is that normal and is it contributing to my rough return to idle
this...
i have a clear hose that is off the carb and connects to the fuel pump. im not sure what this hose is for because while the engine was running i didnt see anything flowing through it after i saw it was broken..
So I've taken my new used boat out a couple times now and everytime I bring it back I see some liquid on the floor . I don't see any holes in the power steering reservoir ... Where else can it be leaking from .
So yesterday on mother's day we took the boat out for a short run on the river by my house. The launch was ok but we had trouble getting the boat back onto the trailer since the launch ramp was perpendicular to the current on the river. When we finally got it on and out if the water one of the...
