Recent content by Marvxyz2

  1. M

    runabout paint

    I have a aluminum runabout (aquaswan) which I would like to paint. The hull below the waterline needs refinished . I would like to use a roller and brush. I believe I can do a nice job my way, however I am not sure what paint would adhere to the aluminum bottom while being exposed to the water...
  2. M

    have paint!!

    I have a 14 ft aluminum runabout called "aquaswan" and I am, going to paint it to look decent. I am going to use a small roller and brush. I've got the above waterline painted an would like to know what kind of paint to use on the areas below the waterline . I know I can look the boat look good...
  3. M

    aluminum aquaswan

    I believe I may have had some pressure treated wood on my boat floor. and when I heard from this site that it would react with the aluminum I removed it. once the wood is removed is there further damage to the aluminum, or is the threat removed. thanks for any possible info.
  4. M

    spark plugs 6 hp evinrude 1990

    spark plug Does any one know if B7H10 is good to use on my 1990 6 hp evinrude 1990? I went to the auto parts store and these are the ones they gave me.
  5. M

    6 hp 1991 evinrude

    I've re built carb rebuilt fuel pump and am on the verge of getting this motor running....but carb doesn't seem to be getting fuel, yet On first start, How long should it take for the fuel to fill carb. and also if I pull the start rope should the fuel squirt out with a lot of pressure?? Marvxyz2
  6. M

    moisture in crancase 69 johnson

    I'm getting a small amount of moisture in my crankcase, and I think it may be getting past my oil filler plugs . I was wondering if I could use rubber o-rings you get at auto parts stores in place of the rubber gasgets on these plugs.
  7. M

    6 hp evinrude will not idle

    I have a 91 6 hp evinrude which i can't get to stay running. Rebuilt carb. squirted gas mix initially go get engine finally started. finally after several squirt starts the engine will start with choke. Will run with coaxing with choke, and after a whill will run at higher RPM but when I try...
  8. M

    6Hp Evinrude

    I have a 6 Hp Evinrude 1990 outboard and have done several carb rebuilds, replaced ignition coil repl;aced output coils and plug wires. The motor easily starts when I have the choke closed, but slows down and stops when I open the choke. Is it possible that I either have a carb problem or fuel...
See more
Top