FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Thank you very much for clearing this up for me. So I should not be worried about not seeing water while in barrel? Is it good to add the tell-tale or no? Any diagram or picture you could point me to the screw? I appreciate it!
Another question for you knowledgeable people. Where is my 1986 Force 35hp tell-tale? Where should I be seeing water come out after the inlet takes it up to the motor leg?
Just the covers to the motor mounts on the side of the leg are removed. I haven't taken them actually off yet. I did take off the front one to see if it freed up more room to move the plate but it did not. So the 2 up above that connect the swivel and base plate, loosen those 2 to get more flex...
So you mean the shock mounts and cover that are below are the cover or the two that are above up under the engine cowl? All this just to change an impeller. What pain. New motor to me, anytng special I need to know thats a pain
So are you talking about the lower mounts below the cover plate or...
Trying to drop the lower unit and the shift linkage is holding me up because the cover plate is in the way. I know there has to be and easier way. Thanks in advance.
