This was a fun project I tackled last summer...just now getting around to taking some pictures of the finished project.
It's a 1983 14' McKee Craft with a 1983 70hp Evinrude. I purchased it from a buddy's brokerage for a grand total of $800. Officially the cheapest boat sold at said Yacht...
I have an Evinrude 1983 70hp on my 14' McKee that I restored. The motor runs pretty well for the most part. I installed a Tach and found my RPM's to be too low. The motor gets up to about 4900prm (30-31mph) and when the throttle is pushed beyond that it hesitates/bogs/chokes...not really sure...
I have a 14' McKee Tri-Hull that I recently restored. I added a tach for diagnostic purposes and I have found the RPMs to be well below reccomended at WOT. The engine is an '83 Evinrude 70hp. Curently at WOT I am getting around 4900rpms at 29kts with a 13.25x17 MWC prop. THe prop has seen...
I am finishing up a restoration on a boat I purchased this winter. The motor is an 83 70hp non-VRO. When I first purchased the boat, it was difficult to get the boat to speed without bumping the choke...then once on plane things ran fine. I rebuilt the carbs and fuel pump, replaced the fuel...
