Hi. I have just inherited a 1978 DT9 Suzuki. It is in good condition except for the recoil spring for the pull cord is stuffed. Is it possible to get one for a motor this old? Any other ideas? Thanks in advance
Hi. I have just been offered a mid 70's Suzuki DT9. The compression is good and it is basically a free motor. Am just wondering if it is still possible to get parts for these? Water pumps etc...
15 ft fibreglass runabout. 1993 90hp tohatsu. 13 3/4 x 17pitch hustler prop. cavitation plate about 15-20mm above the bottom of the hull. it turns 5200rpm at full throttle. not sure of the mph. I believe its in the range it should be. I am not concerned about top speed but interested in a bit...
15 ft fibreglass runabout. 1993 90hp tohatsu. 13 3/4 x 17pitch hustler prop. cavitation plate about 15-20mm above the bottom of the hull. it turns 5200rpm at full throttle. not sure of the mph. I believe its in the range it should be. I am not concerned about top speed but interested in a bit...
Just wondering how much oil a m90a two stroke should use per 20 litres of fuel. It gets varied rpm running so I know it wont be a solid figure but just wanted an idea if the oil pump is working properly or not. It has oil injection in the fuel line before the carb. So far it has used approx...
How hot/cold should a 3cylinder two stroke be at idle? At idle, mine hardly gets any heat into it at all. is this normal? I checked the plugs and two(top and bottom cylinder) have a kind of creamy water/oil type residue on them. Not good. When I put it together I had the block and head refaced...
Tohatsu m90a 1993<br />Which one is the low speed jet? (is there one?)<br />There are two in the main bowl, one is under a rubber cap. It is the smaller one. Is this it?<br />Also, the idle mixture screw. Which way is rich and which is lean?<br />Thanks
I am trying to free up the steering on my 90 tohatsu. I have a bit of time on my hands at the moment so figured now was a good time!<br />I have removed power head, lower unit and mid section. I am stuck now as to how you separate the shaft itself. I know some motors (like suzukis) have a...
On my 90hp, when it runs higher rpms it loses pressure out of the water telltale. Is this normal? It still flows but not as strong as at idle.It has a new water pump. Thanks
I am looking to upgrade my steering to the type that screws onto and runs through the through tube on the outboard. Are the nuts on the cable end all the same size/thread? My engine is a 90 tohatsu.
