Mc Tool's latest activity

  • M
    Mc Tool replied to the thread Dissapointed in 9.9 4 stroke.
    🙂Not trying to catch you , just wanting to make sure it didnt mean something else . Some of these outboards has a lot of letters in...
  • M
    Mc Tool posted the thread Trailer for inflatable in Trailers and Towing.
    I got me an inflatable 3.8m, and ss you can see its still in the spare room stage . The plan was to chuck it and the motor in Ravi (...
    • IMG20260530115258.jpg
  • M
    Mc Tool replied to the thread Dissapointed in 9.9 4 stroke.
    Does "EFI" not mean electronic fuel injection ?🙂
  • M
    Mc Tool replied to the thread Dissapointed in 9.9 4 stroke.
    Mercury does make mention of "dynamic dampening" rubber mounts instead of a ballance shaft ....probly to save weight . Changing the...
  • M
    Mc Tool reacted to boscoe99's post in the thread Dissapointed in 9.9 4 stroke with Like Like.
    I have seen vibration reducing pads that go between the motor's clamp bracket and the transom. Switching to a propeller with less pitch...
  • M
    Mc Tool reacted to redneck joe's post in the thread Random with Like Like.
  • M
    Mc Tool reacted to tphoyt's post in the thread cooking with Like Like.
    Mine came with a couple box’s of bags and a handheld vac I believe but when there gone I doubt I will get more. I have always just left...
  • M
    Mc Tool replied to the thread Dissapointed in 9.9 4 stroke.
    They have 360⁰ crank phasing (both pistons go up and down together )and no ballance shaft so it will dance about at low speeds. You may...
  • M
    Mc Tool replied to the thread Kohler 5E - Runs Great.
    No , but I just bought a Victron blue IP22 smart charger and Im real happy with it . A new brand to me 🙂
  • M
    Mc Tool replied to the thread cooking.
    We looked at vacuum sealers yesterday ....far out , might be convenient but you gotta get the gorse outa your pocket . We actually were...
  • M
    Mc Tool reacted to DeepCMark58A's post in the thread Bayliner contessa wont plane with Like Like.
    Things happen
  • M
    Mc Tool replied to the thread Removing water from gas.
    Syphoning the water off the bottom is less messy . I just tilt the container so one corner is lowest and stick the hose into the corner...
  • M
    Mc Tool replied to the thread This doesn’t look right to me.
    What? nyloc nuts or the prop falling off 😁 Tbh it was a small older VP outboard and I think the prop was held on by a split pin not a nut
  • M
    Mc Tool replied to the thread Random.
    Haha, took to it like a duck to water😆
  • M
    Mc Tool replied to the thread This doesn’t look right to me.
    Yeah you'd think , but thats a nyloc nut and they do work so I guess it comes down to what your used to. If your going to used nyloc...
Show older items
Top