Mc Tool's latest activity

  • M
    Mc Tool replied to the thread Last weekend at the lake.
    I fish lake , river and sea all year round ....but not today ...or yesterday , its blowing westerly like you wouldnt believe . My fence...
  • M
    Mc Tool reacted to Jeff J's post in the thread Rebuilding carbs with Like Like.
    I use petrolatum or the fluid the o-ring will be exposed (gasoline isn’t a good lube) to on nearly every o-ring I install. Oil and gas...
  • M
    Mc Tool replied to the thread my new profile pic.
    I used to be involved in running an annual motorbike rally (we thought the worlds southern most ) and during the festivities usually...
  • M
    Mc Tool replied to the thread 80 HP Mercury trim.
    🙄no , ergo means " there for " ( its latin ) . I dont know where the relays are situated , but here are some Basically little square...
    • Screenshot_2026-08-30-19-46-27-00_40deb401b9ffe8e1df2f1cc5ba480b12.jpg
  • M
    Mc Tool replied to the thread 80 HP Mercury trim.
    Might just be a relay . If your lucky you may be able to swap over the up relay for the down and see if the fault follows the relay ...
  • M
    Mc Tool replied to the thread Repair of door latch.
    Yeah ,before you find out what else they butchered . There is no excuse for that from a boat builder .
  • M
    Mc Tool replied to the thread Penn fathom Electric.
    Well I think that unless you are disabled or doing multiple drops into 600m of water you should wind it up yourself 😁I mean that...
  • M
    Mc Tool replied to the thread Are Yamaha fuel filters universal?.
    Do you think Yamaha make fuel filters ? .....about as much as they make spark plugs ....I wonder just where it is they get them from 🤔🙄
  • M
    Mc Tool replied to the thread What kind of boat is this?.
    Depends what you want ....for instance that would be ok for shallow water spearing . We use a glass bottomed box ( actually a plastic...
  • M
    Mc Tool reacted to JimS123's post in the thread safe? with Like Like.
    We don't need to see the trailer or the boat or even know any of the data. If the trailer has no specs then it's a hard no. The only...
  • M
    Mc Tool replied to the thread non alcoholic beer.
    Ugh 🤮 uk beers are ...well... ugh . They'd be better off learning how to make decent beer that thinkin up stupid names for the crap they...
  • M
    Mc Tool replied to the thread 1962 Evinrude 40hp Lower Unit Leak?.
    All the above ....and it doesnt take much blue smoke oil out the exhaust to slick up the water if your not on the move....gets obvious...
  • M
    Mc Tool replied to the thread I have been working on a new project, Fishing Cart!.
    Surf fishing with those little things 😁😁my surf caster is 14 foot long with a penn 950 spinfisher reel . And I use a 100psi bait cannon...
  • M
    Mc Tool replied to the thread Just cant figure this out....
    I just disconnect the fuel hose at the motor and either run it out of fuel or drain the carbs ....🙄usually both 😁
  • M
    Mc Tool replied to the thread Sand getting into Suzuki 20hp outboard - can I pull it out?.
    Yeah me too , polished the paint right offa many a prop , never had an issue . Biederboat run the motor in a tub or on muffs and try...
Show older items
Top