Mc Tool's latest activity

  • M
    Mc Tool replied to the thread Trail Cam pix.......
    :D yeah , I figured but it did say "3 million ticks each year ". I dont think I have ever seen one here but my cat treatment says "...
  • M
    Mc Tool replied to the thread Wood stove install.
    I put mine ( and anyone else's who I change their oil ) into a 44 gallon steel drum ...I have nearly filled 2 . I strain it thru a...
  • M
    Mc Tool replied to the thread Trail Cam pix.......
    Gee ! the weight alone would drag a deer down ....and the blood loss would be huge ....no wonder they raid gardens , they must be...
  • M
    Mc Tool replied to the thread No tach,no charging.
    Good od AI 🙂
  • M
    Mc Tool replied to the thread Trail Cam pix.......
    I been watching peeps gunning down ( you could hardly call it hunting ) coyotes at good distances on you tube .....I guess the grass is...
  • M
    Mc Tool replied to the thread No tach,no charging.
    On a smaller outboard not necessarily , as in my case with a plastic boat and a motor that does not require a battery to run but...
  • M
    Mc Tool replied to the thread No tach,no charging.
    Yeah , thats what I think too again Yeah , but if one part of a winding is down to earth there would have to be another earthing point...
  • M
    Mc Tool replied to the thread No tach,no charging.
    Yes that can happen but at a 60vac output from the coils .....well if it takes only 60v to push thru the insulation it pretty much...
  • M
    The back voltage you refer to is called excitation and its that which the regulator manipulates to control output voltage . Some alts...
  • M
    I can recommend a Victron Blue IP22 smart charger....should have bought one years ago . My only beef is that the bluetooth range aint...
  • M
    Myself, I would use a newer Smart Charger, at about 8-10 amps, as these can sense when a Battery has sulfated from a long period of...
  • M
    Yeah I been quizzing AI about my quad flywheels and the trigger node differences in production years , and by transposing the question...
  • M
    Mc Tool replied to the thread Wood stove install.
    Local codes round here are a bit strange . If one was to install a wood ( or multi fuel ) burner in ones house it must be compliant...
  • M
    Looks to me like you need to rotate the latch handle 90deg , looks like the latch is in the closed position in the pic. You may have to...
  • M
    Mc Tool replied to the thread Wood stove install.
    I got one similar but with only one hot plate on top . Going to adapt it so can burn used motor oil ( I have nearly 400litres ) , but my...
Top