OK fella's: Its gonna be deck time soon. The transom goes in this weekend and after that, it's time to replace the deck.
I'm using 1/2" exterior CDX plywood covered on all sides with resin and 1.5oz CSM.
Interesting Point: My stringers are all fiberglass! If I weren't at work I'd upload a...
Good! I didn't screw mine up too bad. Mine was more like worm dirt than actual wood. Only 1 4x4" piece was solid enough to take a measurement as to the thickness.
NOW!
I am going to use Exterior Grade CDX plywood for my transom. 2 pieces of 3/4 inch. I'm going to buy it. Let it dry for a few...
OK:
I've been reading up on the polyurethane expanding foam. I will be replacing most of my foam on my restore job and wanted to make sure I've got this right.
In 2lb foam most sites I've read say it provides 60lbs of floatation. I'm taking this to mean that it displaces 60lbs of weight. Is...
First of all: I'm sooo glad I found these forums!
Here's the long and short of it all.
I'm looking at a 1969 Trihull 15' project boat.
Here's what I know.
The back 1/2 of the floor has to be replaced. No doubt the stringers are junk as well. The transom has to be replaced as well because...
Hello All,
Boy am I glad I found this place!
Here's the question.
I'm looking at an old project boat. The guy's asking 400 for boat motor and trailer. (ALL THREE WILL NEED A BUNCH OF WORK)
It has the afore mentioned outboard on it and I know nothing about it. I don't want to spend $40+ for a...
Hello All,
I'm looking into getting an old tri hull boat. It's a 15 footer and will be a long and drawn out project.
It's actual name is "Fish 'n Ski Marine Products."
Anyone know the story on these boats? I'm guessing it's a 1970's model. It's got a 1969 Merc 650 on it and looks around that...
