Recent content by McGvr

  1. M

    1988 30HP losing ignition

    Hey guys, Ok I'm still losing ignition on my 30 hp evinrude. Runs great until it gets warm then I lose the #2 cylinder. I have swapped the coils and the problem did not follow. so I assume the coils are good. Am I looking at a power pack??? or could it be something else?? McG
  2. M

    1988 30HP Evinrude Loosing ignition

    Hey guys need some help. I have a Evinrude 30 HP. It starts up great runs great until it warms up (about 5 minutes at idle) the I loose ignition on the #2 cylinder. could this be the coil breaking down or does it sound like the power pack?
  3. M

    How important is the Thermostat?

    Hi All, I have read several post that refer to the importance of the thermostat. My 1987 30HP Evinrude did not have a thermostat installed when i bought it. I found out while working on it after it over heated, this was after I ran the motor through the mud (Lots Of mud) and destroyed the water...
  4. M

    Are there any Sea Foam Equivalents

    Hi All, I would like to de-carb my motor but the boat supply store does not carry Sea Foam, What other products are Equivalent and do they work the same??? :)
  5. M

    30 HP Evinrude Compression Issues

    Hello everyone, First time on the forum. Can anyone tell me what the "cold" Compression of my 30HP evinrude should be?? I checked it cold (Both plugs removed) and I get 60ish# on both. I added a little Heavy oil and it went to 90# Also- Can the rings be stuck on a motor that has been run fairly...
See more
Top