The plastic inlet tube that goes to the pump and copper tubing, is melted at the top. This motor over heated before I bought it. I was wondering what effect it would have to run the motor with that tube damaged. Doesn't seem like the tube does much but guide the copper tubing.
i just replaced impeller cause no water was coming out of telltale and then only a little water was coming out so I flushed the motor. Now motor ran for a bit and died and couldnt start it back up. Telltale was still coming out slow. Took off lower unit and there was milky water all over the...
I just bought this motor and it was not pumping water at all. Replaced impeller, pump was fine. Now it is pumping water but not much. I only ran it in a bucket for a couple minutes so not sure if once i get on the water it will flow better. Basically my question is is it normal to be flowing...
