Recent content by mfo

  1. M

    1991 yammie overheat

    I have a 150hp yammie pro vee, that has had an intermittent overheat buzzer go off for the last 4 mos. it would happen when i was idling around for an extended time like 5-10 min at 5-6 hundred rpm the first time it happened I took it in and had the w/p replaced all was good until a couple of...
  2. M

    What temp should a head be

    I have a 91 150 proV that had the overheat alarm go off while idling around at very low rpm 500 rpm for 5 min or so , I replaced the waterpump and took the boat out a few times and all seemed well but last week the alarm went off again while doing the same thing idling for awhile So I changed...
  3. M

    eagle fishelite 642

    Does anybody have this unit ? I was wondering if I could cursor back on the "sonar" screen and a waypoint like some hb and lowrance units. thnx mark
  4. M

    fuel filter 150 pro v

    I have a 1991 pro V , that has a fuel filter under the cowl it is clear plastic which looks kinda dark amber now . I wonder if it is time to change this . It looks like it should screw apart, is there an element inside I have tried to twist it open with no luck, or is this a one piece unit...
  5. M

    tilt and trim noise

    I have a 1991 150hp yammie pro V that has started to make a high pitched moan when I trim or tilt down but is fine when going up , any ideas on this and I was wondering how i check the fluid level on this model ? thnx mark
  6. M

    prop wobble

    I was looking at a 1991 150hp pro v to buy and i noticed that it had a little movement side to side probably less than an eigth of and inch but most other props i have grabbed had no movement i rode in the boat and it runs fine and doesn't seem to vibrate at idle is this something to be...
  7. M

    prop woble

    I was looking at a 1991 150hp pro v to buy and i noticed that it had a little movement side to side probably less than an eigth of and inch but most other props i have grabbed had no movement i rode in the boat and it runs fine and doesn't seem to vibrate at idle is this something to be...
  8. M

    which prop?

    I was looking at a 17 ft. charger the pacesetter series which used to be an entry glass boat rather narrow beam anyway it has a 1998 90 hp rude which prop should this use I have looked all over the prop that he has on and can't find a single number , it is a stainless one i think. It seems like...
  9. M

    waterlogged

    I was lookin at a 96 charger to buy and i know the seller mentioned that he had launched a time or 2 without the plug and i was wondering how much water it takes to waterlog the floatation and is the material usually foam? thnx mark
  10. M

    prop curl

    I have a 1989 50 hp force that has the most curl I have ever seen on a prop, it is more curled than most buzz baits i have seen. Does anybody else have one like this and why so much curl? mark
  11. M

    50hp dies under load

    I have an 89 50 hp that i have had for about 2 yrs motor looks and for the most part run like new . I did a leak down on it when i first got it and it was about 2% even when it was cold! now thats perty good. Anyway i took her to the lake over the weekend and was runnin her around as this is...
See more
Top