Thank you to all for assistance with the lower end rebuild.
Re: Mercruiser 165 inline 6
I'm having problems with the valve lash. The orig problem was knocking in the lower end - fixed with machined crank and bearings all around.
I idle the motor at 500rpm to avoid oil spray and while warm...
Ok... I just got my crankshaft re-done at a machine shop. It's for a Mercruiser Inline 6 165 HP I/O.
In the Mercruiser manual, it states to pry the crank and the thrust bearing covers to seat them as you tighten them. I'm not sure I am getting this right and want to ensure they are 100%...
Hello All;
My family has been boating for years and it's time for a new power boat for the cotage.
We will use it to take a few people out at a time - a bowrider is a consideration - we'll also use it for light fishing. Skiing and water tubeing will be a real must.
So we're think of a I/O...
I just replaced the rod bearings after blowing one out that caused a loud knocking noise.
After getting it all back together, she runs fantastic. However, I still have a knock at 3500+ rpm that get's louder with the rpm.
I had no play on the cam or the crank but the noise is deffinitley in...
