Just replaced the oil pump and still have this damn leak. When i replaced the pump i added oil in the gas tank so the motor wouldnt overheat, waiting until the new oil pump filled the lines up.
When i run the motor and turn it off it now drips from the carbs somewhere, runs down to the bottom...
I have a 200hp yahama outboard with a oil pump that constantly leaks. I pulled it off and discovered that two of of the six bearings are shot which causes the oil to leak into the carbs. I bought a new replacement and discovered that they discontinued the old one, and in order to use the new...
So the main piston seal came off (worn out) and leaks every time i trim the boat up or down. I took the motor off the boat yesterday and have access to the back if need be. Most of the bolts on the sides from the unit are sheared off from the attempt to take them off (salt water corroded or im...
This past weekend I was in the process of taking off my lower unit (seal leak). Working to get the bottom bolts off of the power trim/tilt, unfortunately 3 bolt heads sheared right off leaving the bolt inside (salwater corrosion im assuming). How do i get the bolts out?
Only thing I can think...
I went to change my water pump this past weekend, took all bolts off and tried to pull off the lower unit. Unfortunately it did not come off which is odd because i didnt have this problem 2 years ago. Any advice on what i should do?
Do i need to put the motor in gear?
Torch a certian area to...
Hello Everyone,
Heres my issue:
I have a 1998 200HP Yamaha. Was originally on a 20FT Mako, bought a new wiring harness and this is what happened; Push in the key (separated from the throttle box) and the choke works, turn the key and did nothing. I found out later on that one of the wires from...
