Recent content by milliesdad

  1. milliesdad

    Sears Outboard Mdel(?) 60920-(type?)117512b

    I was just presented with this motor. I believe it's an Eska, being an air-cooled single cyl., but I'm not sure. I've been looking all over the net-(probably in the wrong places) to find out the year and HP rating. the throttle is on the motor (not a twist grip) has low speed and hi speed adj...
  2. milliesdad

    Broadview transducer

    If this is wrong forum, please excuse and move, but I didn't see an electronics forum. In my pile of spare parrs, I have a "broadview x-ducer" according to the lable on it. No mfg name or numbers of any kind.It's for trolling motor mount and is foreward shooting (I'm guessing). Thin and bullet...
  3. milliesdad

    Part number help

    Evinrude 50hp-e50tlcud to be exact.(1987 50hp) Is there a VRO oil hose and primer bulb available as a kit? I can fine indivual pieces, but would rather have it in kit-form to make sure I have all the pieces before I start.
  4. milliesdad

    OT-Canvas cover

    How/ what to use for removing mildew and mold from the under side of the canvas boat cover? Is there anything that can be put on it to inhibit the return? Wasn't sure where to post this, feel free to move it.
  5. milliesdad

    New prop needed/ 50HP Evinrude

    I've seen the Michigan Wheel direct replacement props, and the ones that you have to order a separate hub kit (forget what Michigan Wheel calls it. The question is, has anyone any experience with the replaceable hub style? What are the pros and cons? Any "better" available than MIchigan...
  6. milliesdad

    New prop needed/ 50HP Evinrude

    sorry about the double post.
  7. milliesdad

    Prop ?? on 87 E50tlcud

    Please don't move, there was not too much advise on the Prop board. The motor is on a 16 ft Sylvan DeepFisherman. Prop in question is a 11.75 x 17. I hit a rock today and needless to say, the prop needs to be reglated to a spare. Michigan Wheel Vortex props need a hub,sold separately. Has...
  8. milliesdad

    Hit some hard water today

    Took a chunk out of the prop and skeg, but did not hurt the boat. The motor is a 1985 50 HP-e50tlcud. It is a 11.75 x 17- has the number 147A2 stamped on it. Michigan Wheel shows thier "Vortex" prop with a separate hub kit. Are these any good? I've never seen them until I started looking for...
  9. milliesdad

    1985 50HP 'Rude

    Put new waterpump kit in over the winter. Finally had a chance to try to run it on the muffs. I don't know why, but with a fully charged battery, it fired right up. Is there a problem somewhere?;)
  10. milliesdad

    1987 50HPw/working VRO

    My first full season with it comming up. When first firing it up, should I prime the oiling side with the primer bulb from the oil tank? What maintaince is required for the VRO system? I do carry some 2 stroke OB oil for emergency, but I cannot seem to find out what size tank the boat has...
  11. milliesdad

    16 ft ProFisherman question

    I recently bought a 1988 Sylvan ProFisherman. I'd like to know how big the fuel tank in it is.
See more
Top