Recent content by MisfitToon

  1. M

    Newbie prop/hub ?

    Update - put the 15 x 15 on today and headed out. RPM at WOT adjusting trim to get the most out of it was 5150/5200. Speed topped at 28.5, between 27-28 consistently. Water wasn’t too bad, little choppy and 4 adults on board
  2. M

    Newbie prop/hub ?

    May not put it on this weekend, going to be pretty loaded on the 4th so I won’t get push it. I thought the vengeance felt good, just don’t think it was big enough to push the big tritoon. The Enertia was highly recommended, surprised I found one. Once I figure out the hub I’ll update.
  3. M

    Newbie prop/hub ?

    Range is 5000-5800. The 14.5 15P Vengeance lacked speed at 5900/5950. Hoping the 15x15 would get a little more speed and drop me just below max rpm. Guess we’ll see
  4. M

    Newbie prop/hub ?

    Thanks for the info, I love these forums! The tab washer is different on the III, it has the 6 upright tabs as opposed to the 2 fold up tabs. How is that installed?
  5. M

    Newbie prop/hub ?

    That’s not what I want to hear. Can either of these hubs be used? I have an aluminum 16x13 that came on it. Tried a 14.5 x 15 vengeance but only hit 23-24 mph at 5900 rpm. The aluminum hits 28-29 mph at 5800 rpm
  6. M

    Newbie prop/hub ?

    The thrust washer and nut are the same, the one on the right has a 2 piece drive sleeve and longer center adapter, same 15 spline.
  7. M

    Newbie prop/hub ?

    Not solving an issue, just looking for the right prop. 2020 Manitou Aurora, 25’. Mercury 150 4 stroke on her. Found a stainless steel Enertia 15 x 15, came with the hub kit on the right in the pic. The one on the left is the current hub - Flo Torq 2. What’s the difference? The Flo Torq 2 work...
See more
Top