I successfully removed the defective gland on the port cylinder, cannot budge the starboard side. used a heat gun (could not use a torch to much light and wind) any suggestions? ps the starboard side does not leak, however i do belive in murphys law.<br /><br /> mistylady
since i cant get a dealer to install trim tabs, i am wondering if anyone who has installed them, could give some info on overcoming mistakes.<br /><br /> mistylady
i am debating whether to install a set of trim tabs on my 1995 wellcraft238 coastal outboard boat. this model has a full transon and platform. the problem i have is most of the time i have to run with the motor all the way in, adjusting the motor out, causes cavitation and porposing. i fish the...
i have tried everywhere, since garmin has discontinued g charts. i am looking for a chip from new york to capemay including delaware bay.<br /><br /> mistylady
i am experiencing a problem starting my merc 200 2001 efi in colder weather. it will start only if i advance the throttle in the neutral position. i think this a problem since it is an efi motor. any help would be apprciated. i forgot to mention that it starts fine in warmer weather.<br /><br...
THE MERC 200EFI 2 TIME POWERHEAD FAILURE IS DUE TO A FAULTY IGNITION BOX ADVANCING THE TIMING TO THE TOP STARBOARD CYCLINDER. THE LAST TIME THE SAME CYCLINDER WENT AND THE TECH SAID IT WAS A SHORTED WIRE IN THE HARNESS. SHOULD BE ALL DONE NEXT WEEK.<br /><br />...
i have a 2001 merc 200efi. the engine went with 100 hours the first time. they replaced the power head under the ext warranty. it just went again with 65hours. this motor has always been serviced by a mercury dealer. has anybody else had problems with this motor. ps it is still under the...