I’m going to pull those batteries out of the way tomorrow see if there is a hatch under them and look for the pink wire there not that expensive think I’ll pull it out just put one in if that dosnt fix it I’ll dig into no power going to gauge (bad gauge) or whatever it is it will be fixed before...
Thanks a lot guys we are going to have couple warmer days coming up soon.Not sure what the screws are holding onto with the seat I don’t want to take them out then they don’t grab when reinstalling.So I really didn’t want to take stuff apart I’ve got 3 battery’s under center console there might...
05 Kenner 180v model 90 merc.fuel gauge not working wondering where to find sending unit to start testing before throwing parts at it good time of year to make repairs Thanks in advance Mitch
Re: replace lower unit?
more pics of pin and cam also what is trick to get these seals and bushing out they need to come out so when I put the shaft back in I need to put c clip back on
Re: replace lower unit?
Finally had time to tear lower unit down today seeing hoildays are coming and its raining all weekends in NC.How do you know how much waer a cam pin will have before they will not work the only thing I got left to pull out is the shift shaft not sure how to get it out to...
With the lower unit out of the motor.If I can clamp the shift shaft and manually move it from F -N-R and it lock in place all 3 ways would you say that my lower unit is ok or the shift dog is bent because with it up in place it will not go into reverse.Was told by one person its fine and another...
Here are the pics of my problem where the linkage is I need to remove this shaft.I bought a new coupling for 70.00 the splins where worn off it.It is connected to a rod that slids up, it has a flat on it you can feel it drop in place when you rotate it.But when you get the L/U in place it won't...
The shaft in the pic keeps dropping down and will not stay connected to the upper rod the control levers move like they are suppose to. The L/U is installed properly.shifter was in N controls in N prop free spins no rachiting at all.Move the control lever forward N or reverse nothing happings in...
Having problems getting my gearing back in sync after a water pump replacement.I can get it to go foward only and neautral but no reverse.The shift linkage feel out while trying to see what direction the shaft would turn the bottom gear shaft.I can see that there looked like a set screw was on...
was trying to remove wires away to get carbs off pulled a wire loose cap stuck in dis. can't order new ones how do you fix this problem? can you dissasemble the cap and solder it back? where could I get new wires if needed .1968 mercury 500 2 stroke 4cyl...........Thanks Mitch
1988 mercury 45hp classic fifty.I rebuilt the carbs but guess I got in a hurry didnt pay attention on how the little hook thing at the top of the top carb goes.its the part that has 3 fingers that come apart there is a slot at the bottom it attaches to the top carb and it runs down to the bottom...
1993 Johnson 40hp(J40TLETF MODEL #) I just got the boat decided to rebuild carbs get rid of VRO put in a gas only fuel pump, new fuel lines,fuel filter.The boat is back together and I took it out on the water it ran perfect. The only question I have is at the top of both carbureators are 2 ports...
