Recent content by mlcatlopez

  1. M

    Steering rod

    Does anyone know what type of lubrication is best used for the steering rod that slides inside of the tilt tub?
  2. M

    Sending units

    Does anyone know if a sending unit should be welded to gas tank? What are the benefits? Thanks
  3. M

    Electrical problem with float and bilge

    I'm re-wiring my boat and ran into a snag when I tried to connect the bilge pump and the float to the switch panel. :( Does anyone know how I can wire the float, if the bilge is on an on/off switch. :rolleyes:
  4. M

    Electrical problem with float and bilge

    I'm re-wiring my boat and ran into a snag when I tried to connect the bilge pump and the float to the switch panel. :( Does anyone know how I can wire the float, if the bilge is on an on/off switch. :rolleyes:
  5. M

    Custom Stainless Steel Gas Tank

    Yesterday I took my old metal gas tank to a fabricator to manufacture the exact size 44"L x 15"W x 6" D) existing gas tank that has a mechanical gauge. The fabricator phoned and asked if I had the old gauge to replace on the tank other wise it would cost me an additional $50.00 dollars for a new...
  6. M

    Custom Stainless Steel Gas Tank

    Yesterday I took my old metal gas tank to a fabricator to manufacture the exact size 44"L x 15"W x 6" D) existing gas tank that has a mechanical gauge. The fabricator phoned and asked if I had the old gauge to replace on the tank other wise it would cost me an additional $50.00 dollars for a new...
  7. M

    Aluminum VS Polyethylene gas tanks

    Can someone tell me which is a better fuel tank, aluminum or polyethylene? :confused:
  8. M

    Johnson 30HP problem

    I have a 30hp johnson motor, mounted on a 13 foot Boston Whaler. The engine is in great shape.I haven't run the engine in approximately 10 months and I decided to take it out this passed weekend. The gas level was at 1/2 tank full so I topped it off with new gas mixed with the proper amount of...
  9. M

    Drilling hole through hull for fishfinder installation

    Does anybody recommend dilling a 5/8 hole through the hull to accommondate the transducer cable for a 200DX humminbird :confused: ?
  10. M

    Installation of Hummingbird 200DX

    Hi <br /><br />Where is the best place to mound the transducer? :)
  11. M

    Fozen shaft cable stuck inside tilt tube.

    Does anyone know how I can pull out the steering cable from the tilt tube? I have a 30hp motor, mounted to a 13' boston whaler. Any good suggestions would be greatly appreciated. Thanks :(
  12. M

    Frozen Cable inside tilt tube.

    Does anyone know how I can pull out the steering cable from the tilt tube? I have a 30hp motor, mounted to a 13' boston whaler. Any good suggestions would be greatly appreciated. Thanks :(
  13. M

    Fish Finder Help!!!!!!!!!!!!!!!!!!!!!!

    I want to purchase a new fish finder for my 17' boat. I have no idea what model to choose nor do I know why I would have to buy a transducer ( whatever that menas?) as an additional purchase. Can someone educate me on fish finders? :confused:
  14. M

    Gas Tanks

    Does anybody know where I can purchase a 17 gallon gas tank with fuel gauge?
  15. M

    17' Sea Squirt

    Does anyboady know who makes the Seasquirt boat? It's an open fisherman with center console. :confused: [/LIST]
See more
Top