Thank you for all the feedback. I’ve made the decision to install the Airmar B164-20-Ray. It’s going to be a tight fit where I wanna put it but should work fine. I have to admit I’m nervous about drilling a three and three-quarter inch hole through the bottom of the hull, but it has been done...
Also here is the tight space in the bilge where the transducer would barely fit. For some reason this area is a little thicker hull than adjoining areas. The transducer would require a 3 3/4” hole which would fit inside the black lines in the photo. The gasket and large brass nut is...
Here is a photo of where it would go. Looking at bottom of hull. To the right is the front of the boat The keel is just couple inches above the water intake for the deck spray
That's what was in there but it finally failed. I dont want to pull the v8 engine to replace it. $2000 to pull the engine and put it back in plus the cost of the transducer.
Thanks for the feedback. My transducer would only be about one inch ahead of the water intake and approx. 4 inches to the side. My only other option would be a transom mount.
How close together can I have in hull penetrations in my 2006 trophy pro model 2359. I would like to put in a new Transducer in the hull Airmar B164, which is three and three-quarter inch penetration in the hull and it would be approximately 4 inches away from a through haul penetration from a...
