well im pretty sure my solenoid is going bad. When it's cold outside all it does is click click. If you cross it over and start it and get everything warm then it will start the rest of the day. My question is will a ford solenoid work or a lawnmower solenoid. I've read other places that it...
Im thinking i fried my rectifier the other day. Engine wouldn't start, solenoid just clicked. and before i would just get back there and cross it over and after it got warmed up it would start fine the rest of the day. Well i slipped off the terminal the other day and grounded it out for a...
Got a used boat the other day and i think it's needing lower unit seals changed oil and went to the lake the other day and it's a little milky again. My question is. Is replacing the seals a bad job can it be done at home fairly easy. Im fairly mechanically inclined. Also what does this kind...
Bought a boat and it has power tilt/trim the guy said it's supposed to have a 2 wire motor on it but it messed up and all he had was a three wire motor to put on it. Now the three wire motor works but you can only have one wire hooked up at a time blue up or green down. Is there anyway to fix...
Well i was replacing some gaskets on my seaking and noticed some rust starting on the inside of my reeds. Well upon further inspection found out the water tube grommet on the engine side has come apart and blew out the exhaust i guess. Needless to say letting water in my engine. Hopefully i...
Asking this question because at my local pond there is very few people who fish there. Ok there is this old fiberglass boat that has been sitting up there for about 6 or 7 months. Ok now i wouldn't think that anyone would have abandoned this boat because it was tied to the bank but from the...
Has anyone ever heard of these engines. Are they single or twin cylinders. Also how do they compare to a seaking 7.5 performance wise. Know a guy asking 100.00 for one would it be worth that much if in good shape or not.
Ok I have read that the antivenaltion plate needs to set level with the boat bottom. Now on this 10ft. jon it sits way below the bottom of the boat and when in the water the water comes up to the bottom of the motor mount and around the idle relief holes. Now I have made a transom extention...
I was wondering if anyone had a diagram or could tell me how the little coil spring attaches back onto the float. Took the carb apart the other day to clean it and can't remember how exactly it goes back in.
I have a Montgomery Ward Sea King 7.5 and am needing a water pump impellar. Dont know what year but heres what the tag reads
Model k7503113d
serial 1070616
Type xtv52260
If anyone knows where i can find a impeller please let me know
