FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Hey yall I have a problem. I put a new coat of gel coat on my boat and it doesn't seem to be setting up like it did the first time I did it. I think I know what the problem is but not for sure. The first time I did it it was a lot warmer outside (at least 80 degrees) this time it only got to...
I need help with my 1984 50HP Mariner. When I am running my boat I start out at full power but after only a few minutes it sounds like I drop a cylinder. The motor doesn't miss or anything its just like I loose power. but I can shut it down for a bit to fish and when I start it back up it does...
I have a 1984 50 hp mariner. When I went to use the tilt and trim today my motor will lift but will not lower. I can hear the hydraulic unit come on when lifting but nothing happens when try to lower. I checked the wire going into unit and I am getting voltage to unit but nothing happens. Any...
I recently replaced my stator on my 1984 50 hp Mariner . The two yellow wires were not attached to anything and i was told they are for keeping my battery charged. I do not know where they are suppose to go . Can i wire them straight to my battery? If not can someone please tell me where to...
Hey yall I got a problem, just cleaned my carbs on my 1984 50 hp Mariner. all jets are clean needle in good shape but when I go to start it on full choke it starts good but when i take it off choke motor revs high for few seconds then dies .
I'm about to pull my hair out . please help
Hey yall I got a problem, just cleaned my carbs on my 1984 50 hp Mariner. all jets are clean needle in good shape but when I go to start it on full choke it starts good but when i take it off choke motor revs high for few seconds then dies .
I'm about to pull my hair out . please help
