Hi:<br />I have a Bayliner with a VOLVO AQ125 4 cyl engine.<br />The boat run very well for about 4 to 5 hours, and then it start to<br />miss, I though that I had a fuel problem but it was not the problem.<br />After replacing the points with new one, the same thing happen <br />It run very...
Hi Guys <br />I tried the engine post , but I got no response so I tough I would try here<br />I need help with the fresh water heat exchanger on a VOLVO AQ125, The cap is leaking I have replaced the rubber washer and the cap goes on very tightly, but it still leak when I apply power.<br />the...
Hi <br />I need help with the fresh water heat exchanger on a VOLVO AQ125, The cap is leaking I have replaced the rubber washer and the cap goes on very tightly, but it still leak when I apply power.<br />the water is gushing from under the cap.Is there some other washer or sealing ring that I...
Hi all.<br />I have a 1984 Bayliner 1950 with a AQ125 volvo 4 cyl. engine. I need a color coded wiring diagram<br />for the dash, I have an old manual that is very hard to read. I would apriciate any help.<br />Thank you<br />Mario
HI EVERYONE:<br />I HAVE A QUESTION REGARDING WHERE IS THE No 1<br />CYLINDER ON A VOLVO AQ125A ENGINE? I HAVE (2)<br />REPAIR MANUALS, AN OLD ONE AND A NEW ONE,<br />THE OLD ONE SAYS ITS THE ONE NEXT TO THE FLYWHEEL<br />AND THE NEW ONE SAYS ITS THE ONE NEXT TO THE WATER PUMP SIDE, I'M CONFUSED...
--------------------------------------------------------------------------------<br />AFTER A COUPLES OF MONTHS OF COLD, RAIN AND SNOW,<br />I TOUGH I'D BETTER DO SOMETHING CONSTRUCTIVE <br /> http://hometown.aol.com/msmorto/page2.html <br...
AFTER A COUPLES OF MONTHS OF COLD, RAIN AND SNOW,<br />I TOUGH I'D BETTER DO SOMETHING CONSTRUCTIVE :D <br /> http://hometown.aol.com/msmorto/page2.html
Hi Everyone<br /> I have a Volvo Penta AQ125 with an Aluminum valve cover that need to be clean and restored it is now dark grey in color it not pitted just almost black .<br />Any advice on cleaning or buffing to allum. color or should I paint it ? and what type of paint to use on aluminum ...
My U-JOINT has one side that is very stiff,<br />Any Pro & Con on replacing U-JOINT with one that has grease fittings ??<br />Thank you for any replies. :confused: <br /><br />Mario
My U-JOINT has one side that is very stiff,<br />Any Pro & Con on replacing U-JOINT with one that has grease fittings ??<br />Thank you for any replies. :confused: <br /><br />Mario