Any Mirrocraft owners know what this area was used for on the boat? This was covered up by the floor but did not have any foam in it from the factory. It has a protected grommet in the center. The Capt seat would be placed in the upper left of the picture where the stringer is cut.
Well as in the famous words from the Joker.. You haven't seen nothing yet. :)
This was the "fix" for the livewell he removed in the bottom of the boat then covered it with the can spray from in the first pictures. This is being welded on Friday. I'm also thinking about having another .125...
No Title
Splash well and transom is out. It took longer than I thought. What a pain but now I can clean it tomorrow and see how bad the pitting is on the inside.
Tomorrow I'll sand all the white spots, Transom and sidewalls.
Question:
Should I do anything other...
More pictures:
Spray foam fix. :)
Foam removal process and afterward looks.
Cleaned upped:
Top carpet removed and glue removed.
Aluminum inside cleaned.
Transom view:
They had put two 1/4" aluminum plates on the inside and outside of the...
Good morning All,
I purchased this 1992 Mirrocraft last summer which looked great with new carpet and storage/casting deck. After using it a few times I found the casting deck was taking up to much room. I couldn't turn around my seats without having to put my legs up on the deck. I've been...
Hello everyone,
I came across what I think is a great deal but I wanted to see what other think. I have a 16.5 Mirrocraft Aluminum boat. I was planning on replacing the desk this fall. During my search I found the Bellcomb Aluminum Honeycomb Core Panels 1" X 5' X 10' for $100 per sheet. Plus...
Hello all,
I've been reading your site for the last three weeks since I purchased my fishing boat. Have to say this forum is full of very helpful information on motors plus other things like how to preform a drop volt test.
I'm hoping someone might help me with my starter issues. First let me...
