Recent content by mutron77

  1. M

    PTT Locked up on me

    Hi, 86 EV 90<br /><br />Moved the boat to an outside storage area.(in the hot AZ sun). Went out after a few weeks to start the motor and noticed the trim was a little jerky on the way down. Hmmmmm... Started the motor and after I was finished put the motor back to full tilt flipped up the...
  2. M

    Air driven prop

    Hello,<br /><br />I want to use air from a scuba tank to drive a prop.<br />I can find no info on this on the Web. I do remember seeing a guy who got attacked by a shark who developed a personal shark cage that motored around with what seemed to be air driven propellers.<br />As a starting point...
  3. M

    Trim... Tilt.....Whale-tail..........Prop

    Hello,<br /><br />I need some education in a certain area. I have a 17 foot chriscraft runnabout, '85 90 horse EV. Power Tilt, trim and whale tale.<br />My areas of ignorance:<br />What exactly does the whale-tail do????<br />What am I looking for in adjusting the power trim when running.<br...
  4. M

    victory at sea

    Finally got my Chriscraft redeck finished and on the shakedown cruise. The motor ran like a dream. And the boat was stiff and water tight. I think I got a teaspoon of water out of the bilge when I pulled the plug out at the end of the day. Thanks to everyone for the help along the way.<br />H90
  5. M

    DJ......V4 block ground location???????

    Hi <br />I have viewed a couple of posts here about The V4's <br />Block ground cable being prone to unseen corrosion<br />causing starting issues. I think I may have a few of these issues since I have had a few dud turns of the key with the starter just spinning real slow, or just a click. Then...
  6. M

    run gas out of carbs???

    If you are using premixed is it good practice or not<br />to disconnect the fuel line at the lake and let the gas run out of the carbs before you trailer the boat? Or just bring it home with the carb bowls full<br />and hope it don't gum up before you take it out again.
  7. M

    Jason J Evercoat question

    Jason,<br /><br />How is that Skid-No-More holding up for you?<br />I am considering using it on my deck.<br />I have few questions for you.<br />Did you apply with a roller or brush, or spray?<br />The directions do not mention using a roller, they say to dump it out on the deck and spread it...
  8. M

    removing old stuck on stat gasket

    Stuck on cr*p!!!<br />Hey all,<br />What is the best way to get off the old baked on gasket material from the stat housing and spacer and head on my EV 90 without gouging up the surfaces? Is there some sort of chemical that works good?<br />Also, as an experiment, I soaked my old stats in CLR...
  9. M

    no voltage to temp sensor wire

    Hello<br />Over heat horn will not sound during ground test.<br />After inquiring on the forum I was told that there should be 12V to the harness side of the tan wires that lead to the head temp sensors when the key is in the on position. I did this test with my fluke and no voltage. The tan...
  10. M

    Thermostat progress EV 90 '86

    Hi all,<br /><br />Went to the marine shop and eyballed a junker with the powerhead removed and my friend that works there showed me the 'band' below the lower pan that you all were talking about. After that I headed home to determined to rip out those thermostats.<br />Well they are out, and it...
  11. M

    getting at thermostat bolts EV 90 '85 flat

    Hello,<br />I thought it looked easy to get at the thermostats, now I see the dilemma, the two lower bolts are too long to clear lower engine cover. Why not have put in access holes with rubber plugs on the back of the lower cover? Now I am looking at the tray bolts and power head bolts and...
  12. M

    huminbird transducer wire --Repairable???

    Hi got a Wide 128. The transducer connector that plugs into the push in/pull off cradle is now just a frayed wire with a couple of dangling connections.<br />can't find the plug that broke off. Is there any way to rig this to work, or am I stuck $50 for a new transducer??????????<br />thanks<br...
  13. M

    Thermostat EV 90HP '85

    Hello<br /><br />I heard it was a bear changing one of these. Has anyone done it? Mechanic said during tune up that heads were too cool to the touch indicating an open thermo. He said to take it out and run it around the lake and see if it frees up. He said if your hand doesn't start getting...
  14. M

    Evinrude 90 impellar, how long will it last???

    Just replaced the 7 year old impellar on my EV 90 '85 model. They say after a few years of sitting around it is ready to go, worn, dried up etc. Much to my suprise the 7 year old one was perfect looking. Supple, no cracking the arms had a litte curve in them as they conformed to the water pump...
  15. M

    marine starting battery????

    Hi,<br />Is there anything special about a marine starting battery vs a car battery, other than the screw on posts? I want to get my newly carb kitted, impellared, and tuned 90 horse out on the lake this weekend and am a little short on cash for a battery. I see at Autozone that they have...
See more
Top