Recent content by mxhowes

  1. mxhowes

    Circulation water pump- water bypass hole in block-never drilled out . 1998 4.3 Gl

    Sorry about the Warning at the end of the post. This is something I wrote back in 2015 when I first got the boat. For some reason it got attached to this post.
  2. mxhowes

    Circulation water pump- water bypass hole in block-never drilled out . 1998 4.3 Gl

    Re: 1998 4.3GL Had a leak from my water pump mounting bolts (the side that has 2 bolt holes and a water bypass hole) When I removed the pump it looked like the bypass hole was plugged with junk (first picture) I tried to dig it out ...no luck. Started to clean up the surfaces only to find out...
  3. mxhowes

    Some questions about impeller instalation

    Good description of the TS housing and a picture a new housing make mine look pretty sick. The picture attached is what I found in my thermostat when chasing down the cold running problem. Small pieces of impeller and rocks stuck in the opening. The two larger pieces of impeller .... one I found...
  4. mxhowes

    Some questions about impeller instalation

    #3,..... Yer lookin' at it backwards, so yer Left-handed motor appears to turn CW from where yer lookin',.... If yer not sure, bump the starter,... ;) Got too many things disconnected to bump the starter. So it's a left handed engine, therefore turning CCW as viewed buy a driver of a car...
  5. mxhowes

    Some questions about impeller instalation

    New to me 1998 Reinell 4.3GL PBYC 240hrs. Picked up this boat at the end of last season and I am spending some time this winter fixing the things I noticed needed attention. I am in the process of installing a 3862281 impeller into the raw water pump (3857794). I'm mechanically inclined,know...
Top