Recent content by Ned120

  1. N

    What is it part ? Re: 1975 Evinrude 25 hsp

    Directly beneath the carb, is a hose nipple for a very narrow inner diameter hose that loops up to the top left of the motor (facing it from the carb) and plugs into another nipple, not well described in the Clymer manual,that is my only source of help, but possibly the exhaust cover. The only...
  2. N

    What weight is a 1990 Evinrude 100 xp?

    What weight is a 1990 Evinrude 100 xp? thanks.
  3. N

    Lean/rich control setting:'76 Evinrude 25hsp

    Anyone know the number of turns out from a seated position the lean/rich control should be set at? Assistant did not count turns when removing needle.
  4. N

    Corroded Bolts in Aluminum

    Has anyone mastered removing corroded bolts from aluminum housings? Particularly those below the water line (lower ends and waterpumps) are giving me fits.
  5. N

    Corroded Bolts in Aluminum

    Has anyone mastered removing corroded bolts from aluminum housings? Particularly those below the water line (lower ends and waterpumps) are giving me fits.
  6. N

    '75 Johnson 85 horse Control Cables Question

    Am trying to get the right cables for this application: a Johnson 85 on a '75 Montauk Whaler with a Morse MT2 single lever dual action control. The Morse instructions call for Morse 33c red jacket cables but also note a clutch connection and throttle connection kit which sound had to locate...
  7. N

    Throttle cable needed for '75 Johnson 85 hsp

    My boat has a Moore Controls single throw throttle/gear selector (out of Hudson Ohio). The throttle line snapped at a plastic join. Company appears gone. Anyone have a source or a spare? The boat is a 17' Boston Whaler of the same era.
  8. N

    '75 Johnson 85 hsp, what gear to drop lower unit?

    Does the gear the motor is in affect the ability to remove the unit?
  9. N

    Lower unit removal issue, '75 Johnson 85 hsp

    Have followed the manual carefully. All attachment bolts are removed and the shift rod is disconnected. The prop end of the unit came down about 1/16th of an inch but the end close to the hull shows no sign of movement. Soaked the mating surfaces in WD 40 to the extent I can. Tried a rubber...
See more
Top