1986 200 looper .
Shows signs of prior rebuild.
Did the looper engines have the same cooling paths as crossover v6?
Maybe someone has a diagram?
Ty dan
Need a little help with removing the driveshaft retainer nut. I know about a 100ft/lbs. Hold it in place she stubborn in coming out. I need to remove it to inspect the clutch dog and forward gear, customer also bent the prop shaft hiting bottom.
Heat? Penatrating oil?T Trickof the trade?
If you...
i have a 1989 evinrude 110 picked up used not really running. replaced a piston and sleeve. new gaskets. cleaned and rebuilt the carb.'s checked the float leavel, with the omc. float gauge. placed in a test cell and ran it 6 hours breakin time (no-load) checked timing to 26 deg.(two deg...
ok i've looked and looked, but can't seem to find a supplier for the needed tools to do outboard repairs. i'm currently looking for a place that will sell test props. in the automotive field i could look up kent more if i needed speical shop tools. where do i look for marine shop tools?
