Recent content by nguyen80

i have a welcraft cc with a 98 evinrude 115 with a bad compression. i plan to buy a used evinrude motor and i was wondering if my center console controller will work with the used motor thanks.

I am having problem putting the spring , cap and the plastic piece together. below are 2 pics that i upload. can someone point me to the right directions thanks .

my boat have a hard time plane out unless someone stand at the bow for a minute or two. just recently change fuel/water separator, fuel filter, rebuild carbs, new spark plugs, new power pack. the primer bulb stay firm all the time, i m so confuse.:(

I need help with my etec 115.. engine crank and idle fine everytime but once i put it in gear then it will stall and i have to push the choke couple time for it to go. I m guessing the fuel pump or the fuel line assembly . can anybody show me how to test the fuel pump or diagnose this problem ...

i have a etec 115 outboard....E115TSLECM 1998 , idle fine and cruising is fine but once i give some gas, engine cut off. i recently did a compression test and it shown. cyl 1 85psi cyl 2 100 psi cyl 3 70 psi cyl 4 95 psi can you tell me what this meant? i also just bought a adjustable...

hi, i need help find a yellow rubber part on this linkage that open the butterfly in the carb. i soak it in carb solution and it crack off. I have a 98 evinrude E115TSLECM.

hi, my starter is dead and i just bought a used one on ebay. my evinrude starter part is 586283 and i got the old 586283-u18. i was wondering if it work for my evinrude outboard. my engine is E115TSLECM . the 586283-u18 has a bigger drive assembly.