Recent content by nic420

Pressure tested and no leaks. Just need trim motor oil changed/filled. All good now. Thank you.

Replace all the seals?

Replace all the seals?

Will not trim up or down when button is pressed. Makes noise when button is pressed. Sounds like motor is still working. One of the ram was stuck but now freed. Oil is milky color. Please assist.

NVM. Got it. Thanks.

Can't seem to get it to fit around the LP fuel pump. Thank you ahead for any advise.

Don"t know where this piece goes to after replacing the LP fuel pump outside of the VST.

Thank you. Will try to look for the relay.

What do you think about cutting the new grommet to run the wires through and marine caulk after?

LOL. LOL. Ok thank you. That way seems to be the safest way.

I was planning on cutting them and use butt splice connectors. Then heat shrink. What do you think?

I know where to disconect the other wires accept for the blue & green trim wires. I don't think I can disconnect at the trim motor. Maybe at the relay? But don't know where that is located at.

Thank you for the reply. Just the grommet.

Where do I disconnect the trim wires to feed them through the rubber grommet?

So I shouldn't connect the wires according to the chart? I was going to connect the wires according to their color codes. I was going to connect the blue, black, and shield wires according to their colors on the unit.